Because of this I decided to work on Valentines projects for an upcoming craft fair. The above picture is a treat holder I worked on today. From 1 12 x 12 piece of DSP you can make 12 of these treat holders. I used valentine peppermint patties as the candy in the middle. There are other small candies use as well.
Materials:
All My Love DSP
6 inch of red ribbon
Scalloped Tag Topper Punch
Glue dots
Score board
Paper trimmer
Directions:
1. Cut 2x6 inch piece of DSP (note cut just a tad less than 2 inches to fit in the punch)
2. Score at 2 7/8 and 3 1/8
3. Punch both ends with tag topper punch
4. Put a glue dot on back of your candy a place inside
5. Tie ribbon on the top
You can order the materials from my website. Remember to use Host Code GVDWAAEM for orders less than 150$.
Have a great weekend. Enjoy the Super Bowl if your a fan. I’m going to an agility trial.
No comments:
Post a Comment