Simple One Sheet Wonder using Petal Promenade DSP

Hello. Have you heard of One Sheet Wonders before? For those that haven’t it’s a way to make multiple cards from 1 sheet of DSP.  This is done by cutting the paper a certain way. There are many different ways you can do this. The one I’m showing is simple and easy for beginning stampers. One Sheet Wonder cards can be made using 6 inch or 12 inch DSP. For those cards I’ll be showcasing the 12 x12 Petal Promenade DSP. This DSP can be earned free with an order of 50$ or more during Sale-A-Bration.
Directions for cutting the DSP:
1. Cut the 12x12 piece of paper into 3 4 inch pieces.

2. Cut each piece @ 5 1/4 . You will get 2 from each piece with a small piece left. Save this piece as well.

You now can use these pieces to make several cards. Here are some samples:
Card 1-

Card base- Mango Melody
Layering piece- DSP Rectangle glued to front. I applied a piece of ribbon to the DSP before gluing to the card base.
Sentiment- I stamped the sentiment to the label. (This label is also available free during Sale-A-Bration). I then attached it to the card.

Card 2-

Card base-Fun fold that I showed how to make in February 23 blog. I used Highland Heather cardstock.
Layering piece- I took one of the rectangle pieces and cut diagonally. I glued these to the front of the card base.
Sentiment- I cut a label using the new Story Label Punch. I stamped the sentiment on this then glued
to the card. Make sure you only put glue on one side or you will glue your card shut.

Tomorrow I will share more cards I made. If you need / or want anything go to my website to order. Remember Sale-A-Bration ends March 31st. Use Host Code BGAPMXTJ.